H4 Improper Use; H5 Residual Risks; Table 3 Residual Risks - Electrolux NHT8 Manual

H4 Improper use
Improper use is any use differing from that specified in
this manual. During machine operation, other types of
work or activities considered improper and that in gen-
eral can involve risks for the safety of operators and
damage to the system are not allowed.
Improper use includes:
• failure to disconnect the power supply with the main
switch in "O" off position before carrying out adjust-
ment, cleaning, resetting and maintenance opera-
tions;
• failure to disconnect the power supply with the main
switch in off position "O" at the end of the day;
• lack of machine maintenance, cleaning and periodi-
cal checks;
• structural changes or modifications to the operating
logic;
• tampering with the guards or safety devices;
• failure to use personal protection equipment by
operators, specialized technicians and mainte-
nance personnel;
• failure to use suitable accessories (e.g. use of
equipment, ladders, etc., unsuitable for carrying out
maintenance on equipment positioned inside the
machine);
• keeping combustible or flammable materials, or in
any case materials not compatible with or pertinent
to the work, near the machine;
• incorrect machine installation (see chapter E
"Installation and assembly");
• placing in the machine any objects or things not
compatible with washing or that can obstruct/dam-
age the machine or persons or pollute the environ-
ment;
• non-compliance with the requirements for correct
machine use;
• other actions that can cause risks not eliminable by
the Manufacturer.
H5 Residual risks
The machine has several risks that were not com-
pletely eliminated from a design standpoint or with the
installation of adequate protection devices.
Nevertheless, through this manual the Manufacturer
has taken steps to inform operators of such risks, care-
fully indicating the personal protection equipment to be
used by them.
Sufficient spaces are provided for during the machine
installation phases in order to limit these risks.
To preserve these conditions, the corridors and areas
around the machine must always be:
• kept free of obstacles (e.g. ladders, tools, contain-
ers, boxes, etc.);
• clean and dry;
• well lit.
For the Customer's complete information, the residual
risks remaining on the machine are given below; such
actions are to be considered incorrect and therefore
strictly forbidden.
APPLICATION PHASE: I=Installation, U=Normal use,
M=Maintenance, P=Cleaning.
RESIDUAL DESCRIPTION OF HAZARDOUS SITU-
RISK ATION
Slipping or The operator can slip due to water or dirt
on the floor.
falling
[ U - M ]
The operator deliberately or unintention-
Burns
ally touches some components inside the
[ U - M - P ]
machine or dishes at the outfeed without
using gloves or without allowing them to
cool.
Contact with live parts during mainte-
Electrocution
nance operations carried out with the
[ M ]
electrical panel powered. The operator
intervenes (with a power tool or without
disconnecting the power to the machine)
lying down on the wet floor.
Falling from The operator intervenes on the machine
using unsuitable systems to access the
above
upper part (e.g. rung ladders, or climbs
[ I - U - M ]
on it).
During maintenance on the machine or
Tipping of
loads the packing containing the machine with
the use of unsuitable accessories or lift-
[ I - M ]
ing systems or with load unbalanced.
Chemical Contact with chemical substances (e.g.
detergent, rinse aid, scale remover, etc.)
[ I - U - M - P ]
without taking adequate safety precau-
tions. Therefore always refer to the safety
cards and labels on the products used.
Crushing or Possible risk of injury to upper limbs
during the hood closing operation.
shearing
[ I - U - M ]

Table 3 Residual risks

31