Table of Contents
Advertisement
Chapter 2 - Installation
Groove for
metal bands
Tilt control
screws (x2)
Holes for fastening
screws (x4)
To install the Carriage on a 1.5''-4'' pole:
1
Assemble the tilt bracket on the BTS and fasten its four screws (see
"Assembling the Tilt Bracket on the BTS" on page
2
If you use a High-Gain GPS antenna with a cable longer than 3m, install a
lightning arrestor on the carriage as described in
Arrestor for the High-Gain GPS Antenna" on page
3
Thread the four rods through the carriage.
4
Attach the carriage and the clamps to the pole and tighten on both sides using
the supplied washers, spring washers and nuts.
5
Insert the tilt control screws into the middle-side hole of the carriage on both
sides.
BreezeMAX Extreme
Holes for wall
mounting screws (x4)
Holes for lightning
arrestor (x4)
Figure 2-4: BreezeMAX Extreme Pole Mount Carriage
Holes for pole
mounting rods (x4)
29).
"Installing a Lightning
31.
32
BTS Installation
System Manual
Advertisement
Table of Contents
