Advertisement
Available languages
Available languages
Ô
Ô
NOTE
The transmitter's channel setting must be the
same as the receiver setting. If the door chime
occasionally sounds without anyone pressing
BELL, this indicates that the channel settings
are different. Change the channel settings so
both the transmitter and the receiver match.
Ô
Ô
NOTE
• Press BELL until the indicator lights.
Otherwise, the receiver may not work
properly.
• If you don't want to be bothered by the door
chime, slide ON/OFF on the receiver to OFF.
Limited One-Year Warranty
This product is warranted by RadioShack against manufactur-
ing defects in material and workmanship under normal use for
one (1) year from the date of purchase from RadioShack
company-owned stores and authorized RadioShack franchi-
sees and dealers. EXCEPT AS PROVIDED HEREIN, Ra-
dioShack MAKES NO EXPRESS WARRANTIES AND ANY
IMPLIED WARRANTIES, INCLUDING THOSE OF MER-
CHANTABILITY AND FITNESS FOR A PARTICULAR PUR-
POSE, ARE LIMITED IN DURATION TO THE DURATION OF
THE
WRITTEN
LIMITED
WARRANTIES
HEREIN. EXCEPT AS PROVIDED HEREIN, RadioShack
SHALL HAVE NO LIABILITY OR RESPONSIBILITY TO CUS-
TOMER OR ANY OTHER PERSON OR ENTITY WITH RE-
SPECT TO ANY LIABILITY, LOSS OR DAMAGE CAUSED
DIRECTLY OR INDIRECTLY BY USE OR PERFORMANCE
OF THE PRODUCT OR ARISING OUT OF ANY BREACH
OF THIS WARRANTY, INCLUDING, BUT NOT LIMITED TO,
ANY DAMAGES RESULTING FROM INCONVENIENCE,
LOSS OF TIME, DATA, PROPERTY, REVENUE, OR PROFIT
OR ANY INDIRECT, SPECIAL, INCIDENTAL, OR CONSE-
QUENTIAL DAMAGES, EVEN IF RadioShack HAS BEEN
ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.
Some states do not allow limitations on how long an implied
warranty lasts or the exclusion or limitation of incidental or
consequential damages, so the above limitations or exclu-
sions may not apply to you.
In the event of a product defect during the warranty period,
take the product and the RadioShack sales receipt as proof of
purchase date to any RadioShack store. RadioShack will, at
its option, unless otherwise provided by law: (a) correct the
defect by product repair without charge for parts and labor; (b)
replace the product with one of the same or similar design; or
(c) refund the purchase price. All replaced parts and products,
and products on which a refund is made, become the property
of RadioShack. New or reconditioned parts and products may
be used in the performance of warranty service. Repaired or
replaced parts and products are warranted for the remainder
of the original warranty period. You will be charged for repair
or replacement of the product made after the expiration of the
warranty period.
This warranty does not cover: (a) damage or failure caused
by or attributable to acts of God, abuse, accident, misuse, im-
proper or abnormal usage, failure to follow instructions, im-
proper installation or maintenance, alteration, lightning or
other incidence of excess voltage or current; (b) any repairs
other than those provided by a RadioShack Authorized Ser-
vice Facility; (c) consumables such as fuses or batteries; (d)
cosmetic damage; (e) transportation, shipping or insurance
costs; or (f) costs of product removal, installation, set-up ser-
vice adjustment or reinstallation.
This warranty gives you specific legal rights, and you may
also have other rights which vary from state to state.
RadioShack Customer Relations, 200 Taylor Street, 6th Floor,
Fort Worth, TX 76102
RadioShack Corporation
Fort Worth, Texas 76102
3. Install three AAA batteries as indicated
by the polarity symbols (+ and –)
marked inside.
4. Replace the compartment door.
5. Repeat Steps 1-4 for the other
transmitter. If the transmitter's LED
indicator dims, replace its batteries.
I
R
N THE
ECEIVER
1. Slide the receiver's battery
compartment door in the direction of the
arrow to remove it.
2. There are two channel switches inside
the battery compartment —
. Slide the channel switches so
BELL 2
that they are on the same channel as
the transmitter. Ô
3. Install three C size batteries as
indicated by the polarity symbols (+ and
–) marked inside the compartment.
4. Replace the compartment door. If the
receiver's LED flashes with a short
beep tone, replace its batteries.
OPERATION
1. Slide
ON/OFF
2. Press and hold down
1 transmitter. Transmit begins, the
indicator lights, and the receiver sounds
the door chime twice. Ô
3. When
is pressed on the BELL 2
BELL
transmitter, it's indicator lights and the
CONTAINED
door chime sounds "Home sweet
home".
U
C
SING THE
E
C
NTRY
HIME
1. Connect the transmitter to a normally
open alarm sensor. You need 2-
conductor wire (not supplied) to make
this connection.
2. Split the ends of the wire, then connect
the wire from the sensor's switch to the
screw holes on the back of the
transmitter, using the two supplied
machine screws. If the sensor you are
using has both normally open and
normally closed contacts, be sure to
connect to the sensor's normally open
contacts.
3. Slide
ON/OFF
12/99
and
BELL 1
on the receiver to
.
ON
on the BELL
BELL
HIME AS AN
on the receiver to
.
ON
THE FCC WANTS YOU
TO KNOW
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate
radio frequency energy and, if not installed
and used in accordance with the
instructions, may cause harmful interference
to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between the
equipment and receiver.
• Consult your local RadioShack store or
an experienced radio/TV technician for
help.
• If you cannot eliminate the interference,
the FCC requires that you stop using
your door chime.
Changes or modifications not expressly
approved by RadioShack may cause
interference and void the user's authority to
operate the equipment.
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) this device may
not cause harmful interference, and (2) this
device must accept any interference
received, including interference that may
cause undesired operation.
SPECIFICATIONS
Frequency ........................433.92 MHz
Transmitter current consumption...............<10mA
Receiver current consumption...<2mA @ standby
< 130mA @ sound playing
Receiver battery low .......................... 2.4V
Receiver audio power............... > 80dBA @ 25cm
Transmitter operating
temperature ..................................–20
Specifications are typical; individual units might
vary. Specifications are subject to change without
notice.
±
600KHz
±
0.1V
°
°
C to 60
C
°
°
(–4
F to 140
F)
61-2117
AO0185AAA1
11A03
Printed in China
Advertisement
