Radio Shack TAD-733 Owner's Manual page 10

43-733.fm Page 10 Friday, September 17, 1999 8:57 AM
4. To charge the battery pack, place
the handset on the base. The IN
USE indicator flashes for 1 second
and the CHARGE indicator auto-
matically lights after 4 seconds.
Recharge the battery pack when the
LOW BATT indicator on the handset
flashes.
Notes:
• You can place the handset on the
base facedown or faceup without re-
moving the belt clip. If you want to
use the hanging hole on the back of
the handset to place the handset on
the wall-mounted base faceup, re-
move the belt clip (see "Removing
the Belt Clip" on Page 18).
• If the CHARGE indicator does not
light when you place the handset on
the base, be sure the battery pack
and AC adapter are correctly and
securely connected.
10
Also, check the charging contacts
on the handset and base. If the con-
tacts are dirty or tarnished, clean
them with a pencil eraser.
IN USE
Indicator
CHARGE
Indicator
• When you first use the phone after
charging or recharging the battery
pack, the phone might not work and
you might hear 3 short beeps when
you press
turn the handset to the base for about
5 seconds. This resets the security
LOW BATT
access-protection code.
Indicator
• About once a month, fully discharge
the battery pack by keeping the hand-
set off the base until the LOW BATT
indicator lights. Otherwise, the bat-
tery pack loses its ability to fully re-
charge.
• If the LOW BATT indicator does not
light, but the phone does not work, re-
charge the battery pack. (The battery
pack charge might be too low to light
the indicator.)
• If the battery pack becomes weak
during a call, you hear 3 beeps and
the LOW BATT indicator flashes. End
the call as soon as conveniently pos-
sible, and recharge the battery pack
before using the phone again.
. If this happens, re-
TALK