Specifications; Ordering Information - Honeywell M9161V series Product Data

SERIES 90 MODUTROL IV

SPECIFICATIONS

TRADELINE Models: Selected and packaged to provide
ease of stocking, ease of handling and maximum replace-
ment value. Specifications are the same as those of stan-
dard models unless specified otherwise.
M Motor
91
Proportioning Series 90 Control
94
Flame Safeguard Firing Rate Motor
6
60 lb-in. Spring Return
7
8
9
1 Dual-ended shaft
2
4
5
A
B
C
D
E
M 91 8 4 A
NOTE: Torque designation corresponds to torque rating at standard timing (nominally 60 sec for 160° and 30 sec for 90° except
for 300 lb-in. motors which have timings of 2 or 4 min).
Dimensions: Refer to Fig. 2.
Electrical Ratings: Refer to Table 2.
Control Inputs: Proportional, Series 90.
NOTE: Motor Series 90 control can be either Electronic,
or Mechanical (135 ohm).
Auxiliary Switch Ratings: Refer to Table 3.
Ambient Temperature Ratings:
Maximum: 150° F (66° C) at 25% duty cycle.

ORDERING INFORMATION

When purchasing replacement and modernization products from your TRADELINE® wholesaler or distributor, refer to the
TRADELINE® Catalog or price sheets for complete ordering number. If you have additional questions, need further information,
or would like to comment on our products or services, please write or phone:
1. Your local Honeywell Environmental and Combustion Controls Sales Office (check white pages of your phone directory).
2. Honeywell Customer Care
1985 Douglas Drive North
Minneapolis, Minnesota 55422-4386
3. http://customer.honeywell.com or http://customer.honeywell.ca
International Sales and Service Offices in all principal cities of the world. Manufacturing in Belgium, Canada, China, Czech
Republic, Germany, Hungary, Italy, Mexico, Netherlands, United Kingdom, and United States.
63-2631—07
™
MOTORS
Table 1. Modutrol IV Series 2 and 3 Model Number Guide.
35 lb-in. Non-Spring Return
75 lb-in. Non-Spring Return
150 lb-in. Non-Spring Return
300 lb-in. Non-Spring Return
Non-Spring Return
Normally Closed (NC) Spring Return
Non-Spring Return
Normally Closed (NC) Spring Return
0 Auxiliary Switches
1 Auxiliary Switch
2 Auxiliary Switches
0 Auxiliary Switches
1 Auxiliary Switch
XXXX
NOTE: Auxiliary switches can only be added to motors
that include auxiliary switch cams. (These cams
cannot be field-added.)
Modutrol IV Order Number Guide: See Table 1.
Adjustable Stroke
See Catalog for Complete O.S. Number
Minimum: -40° F (-40° C).
NOTE: 25% duty cycle indicates that the motor operates
for 6 out of every 24 hours.
Dead Weight Load On Shaft:
Power or Auxiliary End: 200 lb (90.8 kg) maximum.
Maximum Combined Load: 300 lb (136 kg). (Dual shaft
motors only.)
Crankshaft: 3/8 in. (9.5 mm) square. (All models built after
2006 have dual end shaft.)
2
Normally Closed