Hold-Switch; Status Led - Siemens Ay User Manual

User Manual for AyAlarm
V2.1

3.1.1Hold-switch

This switch prevents unintended button presses, see Figure 3-4. A button press is accepted only in
case the switch is in position "unlock". If the hold-switch is in position "lock" the only accepted
action is the long-press onto the central button, if this is enabled by AyApplication e.g. to enable
emergency calls.
If the AyTerminal is off, the hold-switch on "lock" and long press is performed the AyTerminal will
NOT turn on.

3.1.2Status LED

This status LED is used to provide feedback to the end-user about the current AyTerminal status.
The dual-color LED is able to show the following colors:
•
black (off),
•
green,
•
red,
•
orange (mixture between red and green).
The LED is able to blink within the range from once per 25 seconds (0,04Hz) to 10 times per
second (10Hz).
Following table shows the status of the Status LED depending on the AyTerminal status.
color
green
red
orange
green
orange/green blinking (500msec
green/black
orange/black
green/black
red/black
orange/black
red
Figure 3-4 Hold-switch
Status LED
type
permanent
permanent
permanent
permanent
ORANGE, 500msec
GREEN)
blinking (100msec
ON, 2000msec OFF)
blinking (100msec
ON, 2000msec OFF)
blinking (100msec
ON, 200msec OFF)
blinking (300msec
ON, 300msec OFF)
blinking (300msec
ON, 300msec OFF)
permanent
AyTerminal status
AyTerminal OFF, charger connected,
battery charging mode
AyTerminal OFF, charger connected,
battery charging error
AyTerminal OFF, charger connected,
battery charging finished
AyTerminal ON, startup phase
AyTerminal ON, startup phase, firmware
update
AyTerminal ON, mode active or idle
AyTerminal ON, shutdown phase
(selection of Turn OFF item)
AyTerminal ON, GPRS/SMS/GSM
transmission
•
AyTerminal ON, error indication like:
•
low battery,
•
to many AySnapOn´s connected,
no SIM inserted
AyTerminal ON, AyApplication alarm is
triggered
AyTerminal ON, critical error, device
AyTerminal
AyAlarm application
Hold-switch