Microphone; Ego-Motion Sensor; Temperature Sensor; Oled Display - Siemens Ay User Manual

Table of Contents

Advertisement

User Manual for AyAlarm
AyTerminal
V2.1
AyAlarm application
3.1.6.2Ring tones
There are 7 available ring tones which can be used in AyApplications. With AyCare application
these ring tones can just be played from Settings/ Audio/ Ring tones.
3.1.6.3Alarm tone
Alarm tone is an internal alarm which is used in AyCare for playing siren in case of alarm (if the
mode is defined so).

3.1.7Microphone

The microphone is used for the GSM voice call and/or as noise sensor.
3.1.83D-Ego-motion sensor
The ego-motion sensor is used to detect the AyTerminal movement.

3.1.9Temperature sensor

The temperature sensor provides the information about the AyTerminal environment temperature.
The temperature range is defined by the operating range of AyTerminal with a temperature-
accuracy of +/-1,5°C @ 30°C without charger connected and OLED display off. In case of a
connected charger (OLED display always on), the internal temperature of the AyTerminal will rise
due to the charging process. The AyTerminal will counterbalance this internal heating but the
temperature sensor will have lower environment temperature accuracy due to the battery charging.

3.1.10OLED display

The AyTerminal has a white OLED display with 128x96 pixel resolution which is also the active
display area used for the screen layouts. In standard mode the used font is Tahoma 15x16
proportional and in jumbo mode the font Tahoma 23x24, each font consisting of maximum 128
characters. These fonts allow English and German user interfaces. All characters that are not
supported by the character set of the used font will be shown as '?'.

3.1.11Battery charging

The AyTerminal can be connected to a charger when the device is switched on or off. It takes 3
hours to charge the battery full.
3.1.11.1Connecting a charger & AyTerminal switched off
If the device is switched off and a charger is connected then the charging battery symbol will be
shown on the display. The AyTerminal can be turned on by pressing long the central button.
Charger
Charger
Connected
Connected
Charging
Charging
Battery
battery

Advertisement

Table of Contents
loading

Table of Contents