Memory Dialing; Storing Phone Numbers And Names - Radio Shack 43-3595 User Manual

Choosing the Dialing Mode
Most phone systems use tone dialing which
sends DTMF tones through the phone lines.
However some phone systems still use
pulse dialing such as in rural areas. Ô
The default setting is tone dialing.
Depending on your dialing system, set the
mode as follows:
1. When the phone is in the standby
mode, press and hold
2. Press
VOL/
D D D D i i i i a a a a l l l l
.
3. Press
CH/SEL
and P P P P u u u u l l l l s s s s e e e e
4. Press
END
the base unit to complete the setting.
The handset returns to the standby
mode.
• If you are not sure of your dialing
system, set for tone dialing. Make a
trial call.
If the call connects, leave the setting
as is, otherwise set for pulse dialing.
• If your phone system requires pulse
dialing and you need to send the
DTMF tones for certain situations
during a call, you may "switch-over"
to tone dialing. (Refer to "Tone
Dialing Switch-over" on page 16.)

MEMORY DIALING

S P
TORING
N
AND AMES
Memory Dialing allows you to dial a number
using just a few key presses. Your cordless
CID/MENU
key three times to select
to toggle between
for each setting.
and return the handset to
N
HONE UMBERS
Dialing mode can only be
changed from handset 1
(HS1).
To confirm which handset is
HS1, look at the display
indicating H H H H S S S S 1 1 1 1 or H H H H S S S S 2 2 2 2 .
.
T T T T o o o o n n n n e e e e
Ô Ô
NOTE
19