Adjusting The Headset's Volume - Radio Shack 2-Line 900 MHz Handsfree Cordless Phone Owner's Manual

43-1701.fm Page 16 Wednesday, September 20, 2000 8:48 AM
When you receive a call on a line, the light for that line flashes
and the phone rings or vibrates (if you set the ringer for that line
to ). Press the button for the ringing line to answer the call.
ON
The indicator for that line lights.
Notes:
• When you are using one line and a call comes on the other
line, the phone beeps or vibrates and the indicator of that
line flashes. You can hold the line you are using and
answer the call. (See "Using Hold" on Page 17.)
• When you press a button, a single tone indicates that the
phone has accepted the command. Three tones indicate
that you pressed a button in error or there is severe inter-
ference. (See "Changing Channels" on Page 18.)
• If interference is severe, the keypad might lose communi-
cation with the base and the call might disconnect. If this
happens, return the keypad to the base for about 5 sec-
onds to reset the security access-protection code.

ADJUSTING THE HEADSET'S VOLUME

To adjust the headset's volume, repeatedly press
9 9 9 9
or during a call until the sound level is comfortable.
VOLUME
You can set the headset's volume to one of four levels, and it
remains set even after you hang up.
Note: The keypad sounds 3 beeps when you reach the lowest
or highest listening level.
16
VOLUME
Operation
8 8 8 8