Parameters For Local Digital Display; Description Of The Blocks; Transducer Block - Siemens Pointek CLS200 Digital Operating Instructions Manual

Parameters for local digital display

The values of the following parameters from the measuring and function blocks can be
presented on the digital display. One of the options shown below must be selected in
Mode 13: Display Source (default: 0)
Block

Transducer Block

Transducer Block Electronics
temperature
Discrete Input Function Block

Description of the blocks

Transducer Block
The figure below shows the signal flow of measured values from the sensor through the
Transducer Block into the output value (Primary Value). The parameters of the individual
functions (switch behavior and delay) can be changed via acyclic access (SIMATIC
PDM).
Transducer Block function groups
Sensor Value
sensor
technology
Application
Range,
Lower Limit
Mode 19
Page 86 Pointek CLS200/300 Digital – OPERATING INSTRUCTIONS
: see page 38.
Primary Value
Sensor Value discrete
Sensor Value
Electronic temperature yes
Output
Sensor Value discrete
%
logical switch
sensor
Application Switch
Range, Point 2
Upper Limit (Falling
Mode 20 Edge)
Mode 26
Parameter Can be displayed locally
yes
no
yes
yes
behavior
Switch Fall Time
Point 1
(Rising
Edge)
Mode 25
Primary Value
delay
Time
0
1
Time
1 0
Rise Time
Mode 5 Mode 4
7ML19985JJ03