Local Operation: Pointek Cls200/300 Digital (Standalone); Local User Interface (Lui); Input Keypad; Lcd Display (Local Operation) - Siemens Pointek CLS200 Digital Operating Instructions Manual

Local Operation: Pointek CLS200/300
Digital (Standalone)
• Local operation gives you access to all the functions listed in the table on page 33,
Quick Reference: operating functions using input keypad
• An extended range of functions is available only via remote operation using
PROFIBUS PA: see

Local User Interface (LUI)

You can program the transmitter using the input keypad, and view measuring results,
error messages and modes of operation on the digital display.

Input keypad

Three keys M, ⇑ and ⇓, are located below the display (see
User Interface (LUI)
must be closed again after programming.

LCD display (local operation)

The local digital display shows one of
the following:
• the measured value and associated
units
• the logical level (sensor covered/
uncovered)
• the numerical value and mode
number
• an error message and status
information.
• software revision number
1 – Primary Reading (displays measured value, or logical level, or an error message)
2 – Auxiliary Reading (displays Units, or the Bar Graph, or Status [error code])
3 – Indicator for Write Protection / Mode number/ Simulation
4 – Down arrow indicates alarm output switch open
5 – Negative sign
6 – Up arrow indicates alarm output switch closed
7 – Communication Indicator - visible only when communications are in progress
1.
The current software revision is displayed for 1 to 2 seconds at startup on two
successive screens which are immediately followed by RUN mode display.
7ML19985JJ03
PROFIBUS PA Parameters
on page 32). The keys are accessible when you open the lid. The lid
1
Pointek CLS200/300 Digital – OPERATING INSTRUCTIONS
.
on page 63.
Programming via the Local
1
Page 29