Mounting The Stereo - Radio Shack AM/FM Stereo Cassette Owner's Manual

12-2115a.fm Page 12 Wednesday, January 12, 2000 11:18 AM

MOUNTING THE STEREO

Once you verify that the stereo is con-
nected properly, follow these steps to
mount the stereo.
1. Disconnect the cable from the vehi-
cle's negative (–) battery terminal.
2. Disconnect the wiring harness and
the antenna.
Vehicle's
Wiring
Antenna
Harness
3. Press on the right side of the
REL
control panel to remove it (see
"Removing the Control Panel" on
Page 15).
4. With the supplied keys' tabs facing
inward, insert both of the keys into
the slots between the mounting
sleeve and the stereo and press the
keys toward the back of the stereo.
The sleeve begins to slide off.
Sleeve
12
5. Remove the keys from the slots and
slide the sleeve all the way off.
6. Put the sleeve into the opening in
the dash, then secure it by bending
out all the tabs with a screwdriver.
7. Pull the wiring harness and the
antenna cable through the sleeve
and dash, then reconnect the wiring
harness and the antenna to the ste-
reo.