For Fujitsu Qlogic Fibre Channel Cards - Fujitsu ETERNUS AF Configuration Manual

Chapter 8 Setting Up XenServer
8.1 Setting Up the Fibre Channel Cards
8.1.3

For Fujitsu QLogic Fibre Channel Cards

This section explains how to install QLogic Fibre Channel cards in the XenServer host and how to connect the
ETERNUS DX/AF.
Log in to the XenServer network or use the Console function of XenServer to perform settings.
For the installation procedure and functions regarding XenCenter, refer to the manuals that can be obtained
on the following Citrix web-site:
https://www.citrix.com/support/
Since the standard driver that is supplied with the OS is used for the Fibre Channel driver, other drivers do
not need to be installed.
Use the following procedure to set the drive parameters.
Use the SANsurfer FC HBA CLI or the QConvergeConsole CLI to set the driver parameters. The SANsurfer
•
FC HBA CLI or the QConvergeConsole CLI is installed in XenServer as standard.
For details on how to use the SANsurfer FC HBA CLI or the QConvergeConsole CLI, refer to the command
help.
Set the parameters without the ETERNUS DX/AF connected.
•
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection- (Fibre Channel) for Citrix
21
Copyright 2017 FUJITSU LIMITED
® ®
XenServer
P3AM-4572-19ENZ0