Server Startup And Power Supply Control Notes - Fujitsu ETERNUS AF Configuration Manual

Fibre channel for citrix xenserver

Hide thumbs Also See for ETERNUS AF:

Table of Contents

Chapter 3

Notes

3.4

Server Startup and Power Supply Control Notes

3.4

Server Startup and Power Supply Control Notes

Before turning the server on, check that the ETERNUS DX/AF storage systems and Fibre Channel switches are

all "Ready". If the server is turned on and they are not "Ready", the server will not be able to recognize the

ETERNUS DX/AF storage systems.

Also, when the ETERNUS DX/AF power supply is being controlled by a connected server, make sure that the

ETERNUS DX/AF does not shut down before the connected servers. Similarly, the Fibre Channel switches must

also be turned off after the connected servers have been shut down. If turned off, data writes from the run-

ning server cannot be saved to the ETERNUS DX/AF storage systems, and already saved data may also be

affected.

FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection- (Fibre Channel) for Citrix

XenServer

P3AM-4572-19ENZ0

Table of Contents

Eternus dx