Fluke 281 User Manual page 317

FORCETRG
HOLD <cpd>
LOCKMODE <cpd>
LOCKSTAT <cpd>
LOCAL
LRN <character data>
MOD <cpd>
MODE <cpd>
MODTYPE <cpd>
OUTPUT <cpd>
PHASE <nrf>
POSNMKRCLR <cpd>
POSNMKRPAT <cpd1>,<nrf1>
<nrf2>,<cpd2>
POSNMKRRES <cpd>,<nrf>
POSNMKRSET <cpd>,<nrf>
PULSDLY <nrf>
PULSPER <nrf>
PULSWID <nrf>
PULTRNBASE <nrf>
PULTRNDLY <nrf1>,<nrf2>
PULTRNLEN <nrf>
PULTRNLEV <nrf1>,<nrf2>
PULTRNMAKE
PULTRNPER <nrf>
Force a trigger to the selected channel.
Set hold mode <ON>, <OFF>, <ENAB> or
<DISAB>.
Set the channel synchronization mode to
<INDEP>, <MASTER>, <FTRACK> or
<SLAVE>.
Set the channel synchronization status to
<ON> or <OFF>.
Returns the instrument to local operation and
unlocks the keyboard. Will not function if LLO
is in force.
Install data for a previous
Set the modulation source to <OFF>, <EXT>
or <PREV>.
Set the mode to <CONT>, <GATE>,
<TRIG>, <SWEEP> or <TONE>.
Set the modulation type to <AM> or <SCM>.
Set the main output <ON>, <OFF>,
<NORMAL> or <INVERT>.
Set the slave generator phase to <nrf>
degrees.
Clear all position markers from arbitrary
waveform <cpd>.
Put the pattern <cpd2> into the arbitrary
waveform <cpd1> from start address
<nrf1> to stop address <nrf2>.
Clear the position marker at address <nrf>
in arbitrary waveform <cpd> to 0 (low).
Set the position marker at address <nrf> in
arbitrary waveform <cpd> to 1 (high).
Set the pulse delay to <nrf> sec.
Set the pulse period to <nrf> sec.
Set the pulse width to <nrf> sec.
Set the pulse−train base line to <nrf> volts.
Set the delay of pulse−train pulse number
<nrf1> to <nrf2> sec.
Set the number of pulses in the pulse−train to
<nrf>.
Set the level of pulse−train pulse number
<nrf1> to <nrf2> volts.
Makes the pulse−train and runs it − similar to
the WAVE PULSTRN command.
Set the pulse−train period to <nrf> sec.
Remote Operation
Remote Command Summary
LRN? command.
*
17
17-25