Programming Trunked Frequencies - Radio Shack PRO-2052 Owner's Manual

20-432.fm Page 32 Friday, July 14, 2000 11:30 AM
We recommend you set
the position shown here before select-
ing a trunked bank.
Note: Change this setting as neces-
sary to get the best performance in
your area.
PROGRAMMING
TRUNKED
FREQUENCIES
Before you program your scanner to
track a trunked system, consider the
following:
• Valid trunked system frequencies
are as shown below.
Motorola system :
935.0125–939.9875 MHz
(in 12.5 kHz steps)
851.0000–868.9875 MHz
(in 12.5 kHz steps)
406.0000–512.0000 MHz
(in 12.5 kHz steps)
137.0000–174.0000 MHz
(in 5 kHz steps)
Ericsson EDACS system :
900.0000–956.000 MHz
(in 12.5 kHz steps)
32
to
SQUELCH
• You can use any of your scanner's
• The scanner only scans one
Before scanning a trunked system's
transmissions, you must store the
trunked system's frequencies in one of
the banks in your scanner by following
these steps.
1. Set the scanner for conventional
2. Press a number key to select the
3. Use
806.0000–899.9875 MHz
(in 12.5 kHz steps, except
cellular frequencies)
406.0000–512.0000 MHz
(in 12.5 kHz steps)
137.0000–174.0000 MHz
(in 5 kHz steps)
banks as either a trunk scanning
bank or conventional scanning
bank, but you cannot mix the two.
trunked system at a time. Al-
though you can store frequencies
for more than one trunked system
in one of your scanner's banks,
the scanner only scans the fre-
quencies associated with the first
data channel it finds.
scanning, then hold down
until the scanner beeps twice.
, , and the bank
BANK TRUNK
numbers flash.
bank for the trunked system's fre-
quencies. To select
between 11 and 20, press
then the number keys. The scan-
ner displays one of six system
types.
or to select the system
type, then press .
E
TRUNK
a bank
SHIFT