On A Wall Plate - Radio Shack Caller ID System 999 Owner's Manual

43-999.fm Page 8 Tuesday, August 17, 1999 8:28 AM

On a Wall Plate

Note: Check for the proper viewing an-
gle of the liquid crystal display before
mounting this system to a wall plate.
1. Plug one end of the supplied short
modular phone cord into the
jack on the phone.
LINE
Illustration,
connecting short line cord
2. Route the cord through the strain-
relief slot on the back of the phone.
Illustration,
routing cord through strain relief slot
3. Insert the tabs on the narrow end of
the stand into the matching slots
near the top of the phone, making
sure the cord is routed through the
opening in the stand. Then snap the
stand into place by pressing in the
two tabs toward the bottom of the
phone.
Illustration,
connecting phone stand
8
4. Plug the other end of the phone
cord into the phone jack on the wall
plate.
5. Align the phone stand's keyhole
slots with the wall plate studs and
slide the phone downward until it
snaps into place.
TEL.
mounting phone to wall plate
6. Slide out the handset holder, flip it
over as shown, then slide it back
into place.
flipping handset holder
Illustration,
Illustration,