Changing The Engraving Point; Advice On Use - Parkside PGG 15 A1 Operation And Safety Notes

Note: Take care when increasing the penetration depth that you do
not turn the stroke switch
switch could screw off the device.

Changing the engraving point

performing any tasks on the device and pull the mains plug out of the
mains socket.
Replace the engraving point
and no longer provides the desired engraving performance. Turn
the engraving point holder
point is released.
5
Remove the spring and the plain washer.
Push the plain washer and spring on to a new engraving point
Then insert this and turn the engraving point holder
to lock the engraving point in position.
Ensure that the engraving point

Advice on use

You can use the mini-engraver to produce creative, individual engravings.
For example, you can use it to place identifying marks on your valuables.
You can place numbers and letters on metal, glass, plastic, wood,
ceramic and stone. This is done with the help of the supplied engraving
stencils , see Figs. A and B.
7
Hold the device at an angle, as you would a pencil.
Your arm should rest on the table.
too far in the + direction. Otherwise the
2
RISK OF INJURY! Switch the device off before
5
anticlockwise until the engraving
6
as soon as it becomes too worn
is properly fixed in position.
5
Operation
.
5
clockwise
6
GB/IE 15