Operation; Switching On / Off; Setting The Stroke Rate - Parkside PGG 15 A1 Operation And Safety Notes

General safety advice for electrical power tools / Operation
manufacturer parts only. This will ensure that your device
remains safe to use.

Operation

Never use the device for a purpose for which it was not intended or
with non-original parts / accessories. The use of tools or accessories
other than those recommended in the operating instructions could lead
to you suffering an injury.

Switching on / off

Insert the mains plug into a mains socket.
Switching on:
Press the ON / OFF switch
Switching off:
Release the ON / OFF switch

Setting the stroke rate

The stroke switch
ing. A low setting is normally adequate for most engraving tasks.
Turn the switch for the number of strokes
increase the penetration depth.
Turn the switch for the number of strokes
decrease the penetration depth.
14 GB/IE
.
1
is used to set the penetration depth of the engrav-
2
.
1
in the + direction to
2
in the – direction to
2