Initializing The Ip Phone 2004; Figure 12: Ip Phone Initialization - Nortel 200 Technical Configuration Manual

Technical Configuration Guide:
SOHO Secure RAS with VPN Gateway and VPN Router V1.0 September, 2006

4.3 Initializing the IP Phone 2004

When the IP Phone 2004 is first powered up, you will see the "Nortel" introduction screen. To begin the
initialization process, you must enter a key sequence while the "Nortel" introduction screen appears after
powering your IP Phone 2004. Enter the initialization key sequence by pressing each of the four soft keys once,
and pressing from left to right as shown in Figure below.
If the key sequence is not entered within the first two seconds of the initialization process, your set will be
initialized with previously entered parameters. Powering down and powering up the phone set and trying again.

Figure 12: IP Phone Initialization

As you enter parameters manually, use the BKSPACE or CLEAR soft keys to edit the default entry. BKSPACE
will delete each character as the key is pressed. CLEAR will delete the entire entry.
Enter requested information in the menu fields by pressing the number keys on the dial pad. Press the * key to
enter a period (".") when entering the set's IP address. Pressing OK will record the entry and advance the
initialization to the next parameter. Pressing CANCEL will abandon the manual configuration process and restart
the power-up process.
Each parameter must have a corresponding entry. An error "beep" will notify you if you attempt to advance to the
next parameter without a field entry.
_______________________________________________________________________________________________________________________
44
External Distribution
NORTEL