Preparation; Setting The Day And Time - Radio Shack TAD-799 Owner's Manual

43-799.fm Page 9 Monday, August 16, 1999 9:43 AM

PREPARATION

SETTING THE DAY AND
TIME
Follow these steps to set the day and
time so the TAD records the correct day
and time of the call with each phone
message.
Notes:
• To avoid having to reset the time if
AC power is lost, we recommend
you install a battery before you set
the day and time.
• If you do not complete any step
within 8 seconds, the TAD sounds a
three-tone beep and stops setting
the day and time. Start over at Step
1
1. Press and hold
beeps. The TAD announces, "Sun-
day," and appears on the dis-
01
play.
until the TAD
SET
Note: If necessary, adjust
on the right side of the TAD to the
desired listening level.
2. To change the day of the week,
repeatedly press
REPEAT
backward or
SKIP
until the TAD
desired day of the week.
3. Press . The TAD beeps once
STOP
and announces the time format,
"AM" or "PM."
4. To change the hour, repeatedly
press until you hear the
REPEAT
desired hour.
5. Press . The TAD beeps once
STOP
to confirm the hour setting.
6. To change the minutes, repeatedly
press until you hear the
REPEAT
desired minute setting.
7. Press to confirm the settings.
STOP
The TAD beeps and announces the
day and time.
To check the current day and time at
any time, press .
SET
VOLUME
to move
to move forward
announces the
9