On A Wall Plate - Radio Shack TAD -797 Owner's Manual

43-797.fm Page 9 Monday, August 16, 1999 9:20 AM
4. Insert the supplied AC adapter's
barrel plug into the
the back of the base.
5. Route the adapter's cord through
the strain relief slot on the bottom of
the bracket.
6. Plug the adapter into a standard AC
outlet.
7. Lift the base's antenna to a vertical
position.

On a Wall Plate

jack on
DC IN 9V
1. Insert the bracket's tabs into the
Strain
Relief
Slot
2. Plug one end of the supplied short
3. Insert the supplied AC adapter's
base's lower tab slots as shown,
then press down on the bracket's
clips and insert them into the lower
clip slots.
Lower
Tab Slots
Tabs
Lower Clip Slots
modular cord into the
on the back of the base.
barrel plug into the
DC IN 9V
jack
TEL LINE
jack.
9