Getting Started; Removing The Battery Cover; Removing The Battery; Inserting The Sim Card - SENDO 8E30-00000-000 series Manual

Table of Contents

Advertisement

2

Getting started

2
To use your phone, you must first insert the
SIM card supplied by your network service
provider, and then charge the battery.

Removing the battery cover

Press down on the area on the top of the
battery cover as shown below, slide the cover
down and lift off.

Removing the battery

If you need to remove the battery, press down
on the tab at the centre of the bottom edge of
the battery and lift out.
>
Note:
Always turn your phone off before
you remove the battery.

Inserting the SIM card

>
Note:
You cannot insert or remove the
SIM unless you remove the battery.
Always turn your phone off before you
remove the battery. See the Removing the
battery section above for details.
Slide the SIM into place, starting with the
shorter edge first, making sure that the gold-
colored contacts of the card are facing down,
touching the contacts of the phone.
!
Warning:
of small children. This small part can be
a choking hazard or could be swallowed.
!
Warning:
by scratches or bending, so be careful
when inserting and removing the card.

Inserting the battery

Insert the battery into the phone, starting with
the top edge first. Align the tabs on the edge
of the battery with the tabs on the back of the
phone. Make sure the gold-colored contacts
of the battery are touching the contacts on the
phone. Push down into place.
!
Warning:
the phone's front cover removed.
[[[
]]]
4
Keep all SIM cards out of reach
The SIM card is easily damaged
Do not insert the battery with

Advertisement

Table of Contents
loading

Table of Contents