Biostar M6VLQ Grand Manual page 42

M6VLQ Grand BIOS Setup
Input/ Output features.
Power Management Setup
This submenu allows you to configure the power management features.
PnP/PCI Configurations
This submenu allows you to configure certain "Plug and Play" and PCI options.
PC Health Status
This submenu allows you to monitor the hardware of your system.
Frequency/ Voltage Control
This submenu allows you to change CPU Vcore Voltage and CPU/PCI clock. (However,
this function is strongly recommended not to use. Not properly change the voltage
and clock may cause CPU or M/B damage!)
Load Optimized Defaults
This selection allows you to reload the BIOS when the system is having problems
particularly with the boot sequence. These configurations are factory settings optimized
for this system. A confirmation message will be displayed before defaults are set.
Set Supervisor Password
Setting the supervisor password will prohibit everyone except the supervisor from making
changes using the CMOS Setup Utility.
Set User Password
If the Supervisor Password is not set, then the User Password will function in the same way
as the Supervisor Password.
set, the "User" will only be able to view configurations but will not be able to change them.
You will be prompted with to enter a password.
If the Supervisor Password is set and the User Password is
4