Appendix B - Other Ip Setup Methods - Axis 2100 User Manual

Other IP Setup Methods
54

Appendix B - Other IP Setup Methods

In addition to the ARP command (described earlier in this guide), you can alternatively set
the IP address for your AXIS 2100 using any of the following methods - as appropriate for
your operating system:
Method
AXIS IP Installer
BOOTP
Requiring a BOOTP daemon on your system, this
method operates over the entire network. A
request to an active daemon initiates a search of
the boot table to find an entry matching the unit's
Ethernet address. The daemon replys with the IP
address for the device, if a match is found.
DHCP
This method should only be used if you know which
IP address the DHCP server will give the camera, or
if your version of DHCP can update a DNS server,
which then allows you to access the camera using
a name.
Notes:
•Do not use the default or IP address featured in these examples when installing your AXIS 2100.
If in doubt, consult your network administrator to obtain an unused IP address.
•Make sure the AXIS 2100 is powered up and attached to the network.
•Server Privileges: Although no special privileges are required for Windows 95/98, you do need
Administrator privileges for Windows NT/2000, and Root privileges on UNIX systems.
Ethernet Address: The AXIS 2100 is pre-configured with a unique Ethernet Address based upon the serial
number printed on the underside label of the unit; where the serial number typically follows the format
00-40-8c-xx-yy-zz. You must know the Ethernet address to complete the installation.
AXIS 2100 User's Manual
Operating Systems
Windows 95/98/ME and
NT/2000
UNIX
Most
Refer to...
Using the AXIS IP Installer, on page 55.