Dometic RM 2352 Installation And Operating Instructions Manual page 8

CHANGING DOOR SWING TO OPPOSITE
SIDE
A special Hinge Kit must be used to change door swing.
For further information please contact The
listed on the front page.
INSTRUCTIONS FOR MOUNTING THE
DOOR PANEL
The refrigerator is normally delivered without door panel.
The lower decoration strip and parts bag are taped in-
side the door.
Before starting the mounting work, check that the panel
dimensions are in compliance with those given in the
Table and the instructions are read thoroughly.
We recommend to mount the panel on the door before
the refrigerator is installed in the enclosure.
When mounting the panel, proceed as follows:
Slide the panel from the bottom of the door into the
grooves on the vertical edges of the door.
Push the panel upwards, take the
stops from the parts bag and put them in the
holes at the lower door frame.
Put the decoration strip across the door and fasten
it with three screws from the parts bag.
REFRIGERATOR
MODEL
RM 2352
RM 2353
Fill in "XXX" with color code numbers. For color codes, contact your supplier.
CERTIFIED VENT SYSTEM KITS
KIT
NO.
2A
3A
PANEL DIMENSIONS
MAX. THICKNESS 5132" (4 mm)
HEIGHT
TYPE
COMPONENTS
R o o f B a s e
Roof Cover
Lower Side Vent
Lower Side Vent
Upper Side Vent
Upper Side Vent
Lower Side Vent
Power Vent Asm.
Upper Side Vent
Upper Side Vent
Upper Side Vent
Lower Side Vent
Lower Side Vent
W I D T H
MIN.
MIN.
498
PART NO.
RM183
RM123
RM183
RM123
3107560.041
RM163
3107560.009