Where To Go Next - Cisco Catalyst 3850 Hardware Installation Manual

Switch Installation
Voice over IP (VoIP) service and the emergency calling service do not function if power fails or is disrupted.
Warning
After power is restored, you might have to reset or reconfigure equipment to regain access to VoIP and
the emergency calling service. In the USA, this emergency number is 911. You need to be aware of the
emergency number in your country. Statement 371
Category 5e and Category 6 cables can store high levels of static electricity. Always ground the cables to
Caution
a suitable and safe earth ground before connecting them to the switch or other devices.
Noncompliant cabling or powered devices can cause a PoE port fault. Use only standard-compliant cabling
Caution
to connect Cisco prestandard IP Phones and wireless access points, IEEE 802.3af, or 802.3at
(PoE+)-compliant devices. You must remove any cable or device that causes a PoE fault.

Where to Go Next

If the default configuration is satisfactory, the switch does not need further configuration. You can use any
of these management options to change the default configuration:
• Start the Network Assistant application, which is described in the getting started guide. Through this
• Use the CLI to configure the switch as a member of a cluster or as an individual switch from the console.
• Use the Cisco Prime Infrastructure application.
OL-26779-05
GUI, you can configure and monitor a switch cluster or an individual switch.
Catalyst 3850 Switch Hardware Installation Guide
Where to Go Next
21