Power Cord - JVC NX-T10 Instructions Manual

Speaker layout
Main unit
Left speaker
This System is designed to provide virtual surround sound
by positioning the 3 speakers in front.
Omni-Directional Speakers provides a wide sound field
and realistic acoustic ambience.
• When it is difficult to place the speakers as illustrated
above, you can adjust the output level of the speakers to
have a better sound effect. See page 42.
CAUTION:
When installing the left and right speakers on a wall:
• When installing the speakers on a wall, be sure to have
the speakers installed by qualified personnel.
• DO NOT install the speakers on the wall by yourself
to avoid unexpected damage from them falling off the
wall due to incorrect installation or weakness in wall
structure.
• Care must be taken in selecting a location for speaker
installation on a wall. Injury to personnel or damage
to devices may result if the installed speakers interfere
with daily activities.
9
#
System cable
Subwoofer
Right speaker
Connect the system cable with the arrow side facing up.
How to attach the core filter
Attach the provided core filter to the system cable, then the
core filter reduces interference.
1
Release the stopper of the core filter.
2
Run the system cable through the core filter, and place
the core filter at the root of the connector connected
to the subwoofer.
3
Close the core filter until it clicks shut.

‹ Power cord

Connect the power cord of the subwoofer after other
connections have been completed.
The
STANDBY lamp on the subwoofer light red.
Arrow
Core filter (supplied)
lamp on the main unit and the POWER ON/
System cable (supplied)
From the main unit