Yamaha N-100 Service Manual page 12

N-100
14. Speaker Box Assembly
(Time required: About 5 minutes)
14-1 Fully open the keyboard cover until it is placed
upside down and away from you. (Fig. 4)
14-2 Lay a soft cloth such as a blanket, and put the
finished product on it carefully with the keyboard
side facing upward. (Fig. 14)
* For safety purpose, the work should be done
by two people.
14-3 Place thick books (or similar things) under the
speaker box assembly so that the speaker box
assembly is placed parallel to the floor. (Fig. 19)
Connector assembly PK-LF
Front leg assembly
12
[9aB]
Pedal assembly
[9aA], [9aB]: Pan Head Screw 6.0X16 MFZN2B3 SP (WG15760)
∗
: not available as spare parts (Refer to parts list.)
Connector assembly WF
(Fig. 20)
14-4 Disconnect the AC cord and pedal cord (connector
assembly PK-LF) from the bottom of the main unit.
(Fig. 19)
14-5 Remove the pedal box assembly.
(See procedure 12-3)
14-6 Remove the four (4) screws marked [9aA], slide the
speaker box assembly a little, and disconnect the
speaker cord (connector assembly WF) from the
bottom of the main unit. The speaker box assembly
can then be removed. (Fig. 19, Fig. 20)
* To prevent the finished product from falling
backward, work while holding the main unit.
[9aA]
Books
Speaker box assembly
Front leg assembly
(Fig. 19)
15. Front Leg Assemblies
(Time required: About 3 minutes)
15-1 Fully open the keyboard cover until it is placed
upside down and away from you. (Fig. 4)
15-2 Lay a soft cloth such as a blanket, and put the
finished product on it carefully with the keyboard
side facing upward. (Fig. 14)
* For safety purpose, the work should be done
by two people.
15-3 Remove the four (4) each screws marked [9aB].
The right and left front leg assemblies can then be
removed. (Fig. 19)
* To prevent the finished product from falling
backward, work while holding the main unit.
AC cord
[9aB]
Cloth
∗