Honda GX25 Owner's Manual page 31

Carefully remove blade
1
guard and make sure
blade bolts are tight.
(Use 8mm closed end
wrench for Lazer blades)
Remove Metric Allen
2
wrench attached to the
neck of the auger and
unscrew the collar bolt
from auger.
The large and small
2a
holes from each
component must line
up before installing
the collar bolt.
Push down and twist
to line up holes.
1. Turn kill switch to the "ON" position.
2. Pump the primer bulb until it is full of fuel.
3. Move the choke lever to the "START" position.
4. SLOWLY pull recoil handle out until the flywheel engages.
5. Pull the recoil with an assertive, short pull.
6. Pull the recoil until the first audible "fire" of the engine is heard (Should be 2-4 pulls).
7. Quickly move the choke lever to the "RUN" position.
8. If the engine dies, pull over 1-2 more times.
Light pressure on the throttle lever after startup may be needed in extremely cold conditions raising the engine's
RPMs to warm up the motor.
After using this machine, STOP the engine by allowing the engine to
return to idle and moving the switch to the OFF position. If engine fails
to stop, move choke lever to start position. DO NOT OPERATE until this
issue has been repaired by a qualified mechanic. Always check to make
sure the throttle system is moving freely and returning to idle. Turn off
this machine when traveling from fishing site to fishing site. Always
store auger with blade guard attached.
ASSEMBLY
1
3
Lazer
Blade
3a
2
Metal Collar
Allen
Wrench
Collar Bolt
Plastic
Collar
4
2a
Large
Holes
SIMPLE START-UP STEPS
It is recommended to
grease inside metal collar and
transmission output shaft on the
powerhead. Standard automotive
wheel bearing grease is suggested.
Insert drive shaft into auger and
install collar bolt.
Collar bolt inserts into the large
hole, passing through the drive
shaft and threads into small hole
of metal collar. Tighten bolt. Some
wiggle is normal between the power
head and auger. Tighten often.
After assembly is complete, you
can conveniently store your allen
wrench on the underside of the
throttle pedal.
It is recommended that the blade
and collar bolts be checked and
torqued firmly before and after
every use.
3
Output Shaft
3a
4 4
Allen Wrench
Storage