Electric Motor Components - MULTIQUIP MP25E1 Operation Manual

HEAVY DUTY ELECTRIC MOTORS
The MP2 Saw can be equipped with several different models
of electric motors. Figure 4 shows the basic components of
the electric motor. Refer to the manufacturers electric motor
manual for instructions & details of operation and servicing.
1. Electric Motor — The MP2 saw can be operated with
either a Single Phase or Three Phase 230V motor. Only
qualified electricians should service the motor.
WARNING
All saws equipped with three phase motors should
be wired by a qualified electrician and correct motor
rotation verified before operating the saw.
2. Power ON/OFF Box — To turn on the saw, place
switch in the ON position. Place in the OFF position to
shutdown the saw.
3. Electric Motor Reset Switch — This switch is part of
the thermal overload protection for the electric motor. If
the motor overheats and shuts down, press this switch
to reset the motor, after allowing the motor to cool down.
This is used on Single phase electric saws only.
PAGE 14 — MP2 SERIES MASONRY SAW • OPERATION MANUAL — REV. #3 (10/17/17)

ELECTRIC MOTOR COMPONENTS

Figure 3. Electric Motor Components
4. Water Pump AC Power Receptacle — Plug the
electric water pump into this receptacle to provide
power to the pump during saw operation. Unplug the
electric water pump from this receptacle when dry
cutting.
5. Electric Motor Wiring Pigtail — The saw motor ships
with cable "pigtails." Have an licenced electrician
supply and install the appropriate NEMA connector.
DANGER
NEVER grab or touch a live
power cord with wet hands, the
possibility exists of electrical shock,
electrocution, and even death!
NEVER use a damaged or worn
extension cable when connecting
to a power source. Defective cables may cause damage
to the saw's electric motor or electrical shock.