Hitachi G200 Service Manual page 114

Procedure
1.
2.
3.
4.
5.
6.
114
Pull up the stopper of the drive handle toward you to release the lock.
Open the handle toward you, and then gently remove the drive to be
replaced.
Handle the drive with care.
Wait at least 30 seconds. Then place the new drive into the guide rail and
slide it gently in the direction of the arrow.
Push the lower part of the drive until it reaches the position where the
hook on the handle engages with the square hole on the frame.
Pull the stopper lightly, close the handle, and then press the stopper to
engage the lock.
If the hook of the handle cannot enter the square hole, the drive cannot
be installed properly because it gets blocked by the frame of the storage
system.
Pull the drive handle gently to make sure the drive is installed securely
and cannot be pulled out.
Service Guide for VSP Gx00 and VSP Fx00 Models
Replacing a drive