Starting Warm Engine - Echo SHC-2401 Operator's Manual

4. Starting - Lay trimmer on a flat, clear area. Firmly grasp throttle
grip with left hand and fully depress throttle trigger to wide open
position. Rapidly pull recoil starter handle/rope (E) until engine
fires (or maximum five [5] pulls).
5. After engine fires (or five [5] pulls), move choke lever down to
"RUN" position. Hold throttle trigger fully depressed and pull
recoil starter handle/rope until engine starts and runs. Release
throttle trigger and allow unit to warm up at idle for several
minutes.
NOTE
If engine does not start with choke in "Run" position after 5 pulls,
repeat instructions 4 and 5.
6. After engine warm up, gradually depress throttle trigger to increase
engine RPM to operating speed.

STARTING WARM ENGINE

The starting procedures is the same as Cold Start except DO NOT close
the choke.
WARNING
Blades should not move at idle. If blades move, readjust carburetor
according to Carburetor Adjustment instructions in the manual or
see your ECHO dealer, otherwise serious personal injury may
result.
1. Stop Switch - Start/Run. Move stop switch button (A) forward away
from the STOP position.
2. Primer - Pump Bulb. Pump primer bulb (C) until fuel is visible in the
clear fuel return line.
3. Start - Pull Rope. Lay the trimmer on a flat clear area and pull the
recoil starter handle (E) until the engine fires.
NOTE
If engine does not start after 5 pulls, use Cold Start Procedure.
DANGER
S H C
HAFT EDGE
O ' M
PERATOR S
E
A
C
E
LIPPER
17
ANUAL