Panasonic FZ-G1 series Operating Instructions Manual page 22

Installing Software
13 When Ending process screen is displayed, touch [OK] to turn off the
computer.
14 Turn on the computer.
l If the password is requested, enter the Supervisor Password.
15 Perform the "Setup Windows" (è page 8).
16 Start the Setup Utility and change the settings as necessary.
n Using Recovery Disc
Use the Recovery Disc in the following conditions.
Ÿ You have forgotten the administrator password.
Ÿ Installation is not complete. The recovery partition in the fl ash memory may be broken.
Ÿ
To change OS from Windows 7 to Windows 10, or vice versa.
NOTE
l
partition in the fl ash memory.
Preparation
l Prepare the following items:
• Recovery Disc (
disc.)
(è
• Commercially available optical drive
l Remove all peripherals and microSD memory card, etc. (except for the commercially
available optical drive)
l Connect the AC adaptor and do not remove it until installation is complete.
NOTE
l You can use the following buttons instead of the keyboard when the Setup Utility screen is
displayed.
: → key
: ↓ key
: Enter key
: ESC key
: F2 key (Default setting)
1 Connect the commercially available optical drive to the USB port.
2 Start the Setup Utility.
A Touch
B Touch [Restart now] under "Advanced startup".
C Touch [Troubleshoot] - [Advanced options] - [UEFI Firmware Settings] - [Restart].
Turn on the computer, and touch top left of the screen while [Panasonic] boot screen is
displayed.
l If the [Panasonic] boot screen is not displayed, turn on the computer while touching top
left of the screen.
l If the password is requested, enter the Supervisor Password.
22
<Only for Windows 7 downgrade model>
To change OS from 32-bit to 64-bit, or vice versa, install OS using the recovery
Reference Manual "Recovery Disc Creation Utility")
(Start) - [Settings] - [Update & security] - [Recovery].
USB memory device can also be used as a recovery