Download Print this page

Controls & Features - MTD Procut 700 series Operator's Manual

Advertisement

Controls and Features
Bail Drive Control †
Blade Brake
Clutch Lever †
Electric Starter Push Key †
Recoil Starter
† If Equipped
Bail Blade Control
The bail blade control is attached to the upper
handle of the mower. Depress and squeeze it
against the upper handle to operate the unit.
Release it to stop engine and blade.
WARNING: This bail blade control
is a safety device. Never attempt
to bypass its operations.
Bail Drive Control (If Equipped)
The bail drive control is located on the
underside of the upper handle and is used to
engage the drive. Squeeze it against the upper
handle to engage the drive; release it to stop
mower from propelling.
Blade Brake Clutch lever (If Equipped)
The blade brake clutch (BBC)lever is located on
the right side of the upper handle and is used to
engage the blade brake clutch. Squeeze bail
blade control against the upper handle, push
BBC lever to the end until heard a sound then
release it to start blade.
Grass Catcher
Battery †
Cutting Height Adjustment Lever
The adjustment lever is located on the right rear
wheel. To adjust the cutting height, refer to the
"Assembly & Set up" section.
Electric Starter Push Key (If Equipped)
The electric starter push key is located on the
right side of the upper handle. It is both a
removable key and push button and is only
provided on electric start models.
NOTE: On select units, the electric start is
activated by a removable turn key.
Grass Catcher
The grass catcher,located at the rear of the
mower, is used to bag the grass clippings for
disposal at another site. Once the bag is full,
remove it using the handle provided and empty
it before any further mowing.
Primer (If Equipped)
The primer is located on the front of the air
cleaner. Pressing the primer forces fuel directly
into the engine's carburetor to aid in starting the
engine.
Bail
Blade
Control
Throttle Control
Remote Air Cleaner
Rear Discharge Door
Cutting Height
Adjustment Lever
Figure 4-1
Primer †
Recoil Starter
The recoil starter is attached to the right upper
handle. Stand behind the unit and pull the recoil
starter rope to start the unit.
Throttle Control
Throttle Control is located on the left upper
handle. Throttle control maked for "Stop","Start"
and "Run" positions.
4
9

Advertisement

loading

This manual is also suitable for:

Procut 900 series