TP-Link Archer C50 User Manual page 30

Chapter 4
• Wireless - Enable or disable wireless network.
• Wireless Network Name
must be assigned to all wireless devices in your network.
• Mode - You can choose the appropriate "Mixed" mode.
• Channel - This field determines which operating frequency will be used. The default
channel is set to Auto. It is not necessary to change the wireless channel unless you
notice interference problems with another nearby access point.
• Channel Width - This field determines which operating frequency will be used. It is not
necessary to change the wireless channel unless you notice interference problems
with another nearby access point. If you select auto, then AP will choose the best
channel automatically.
• Enable SSID Broadcast
name (SSID).
• Enable WDS - You can select this to enable WDS Bridging, with this function, the router
can bridge two or more WLANs.
NOTE: If this checkbox is selected, you had better make sure the following settings
are correct.
• SSID (to be bridged)
client. You can also use the scan function to select the SSID to join.
• MAC Address (to be bridged)
connect to as a client. You can also use the scan function to select the MAC Address
to join.
• Scan - Click this button, you can search the AP which runs in the current channel.
- Enter a value of up to 32 characters. The same Name (SSID)
- If enabled, the router will broadcast the wireless network
- The SSID of the AP your Router is going to connect to as a
- The MAC Address of the AP your Router is going to
Configure the Router in Wireless Router Mode
25