Table of Contents
Advertisement
SETTING UP WATERING PROGRAMS
SETTING STATION RUN TIMES
The Station Run Time is the length of time the Station will water during the programmed watering cycle.
Run times can be set from 0 (off) to 12 hours, 59 minutes, in one-minute increments.
A Station is assigned to a Program when it is given a run time. If the run time for a Station is set to zero
(0:00) in a program, that Station will not be watered in that Program.
In the example below, Program 1 has been set to
water Station 2 for 30 minutes.
1
Select
SET STATION RUN TIMES
Control Dial.
This will cause the
to flash.
2
Use the
button to select the
required.
3
Use the
and
Station
number.
4
Press
and
HOUR
buttons to set the number of hours of
wateringrequired on that Station. Typically,
this will be 0, but could be up to 12.
5
Press
and
MIN
required on that Station.
6
Repeat steps 2 to 5 until all
SUSPENDING AUTOMATIC WATERING
To stop all automatic watering cycles, turn the
Control Dial
to OFF. The display will show
OFF.
All programmed information will be retained and
the clock will continue to run.
To resume the programmed watering schedules,
Control Dial
turn the
to
begin from the next scheduled start time.
CLEARING ALL PROGRAMS
All programmed information can be cleared.
1
Select
AUTO RUN
on the
2
Press and hold the
This removes all programming but does not reset the clock and calendar.
on the
Station No
Program
buttons to select the
will flash. Use the and
will flash. Use the
Station Run Times
ALL
AUTO
RUN. Irrigation will
Control
Dial.
,
,
and
STATION
2
No
and
buttons to set the number of minutes of watering
have been programmed for all Programs.
buttons simultaneously for 5 seconds.
10
PROG
1
0: 30
RUN TIME
No
HOUR
MIN
Hide quick links:
Advertisement
Table of Contents
