◦
Voltage and percent load
◦
Engine temperature
◦
Oil pressure
◦
Battery voltage
◦
Engine runtime hours
• Date and time displays
• Smart engine cooldown senses engine temperature
• Digital voltage regulation: ±1.0% RMS no-load to
full-load
• Automatic start with programmed cranking cycle
• Programmable exerciser can be set to start
automatically on any future day and time, and run
every week or every two weeks
• Three exercise modes
• Front-access mini USB connector for SiteTech
connection
• Integral Ethernet connector for Kohler
• Built-in 2.5 amp battery charger
• Remote two-wire start/stop capability
• Diagnostic messages
◦
Displays diagnostic messages for the engine,
generator, and programmable interface
module (PIM)
◦
Over 70 diagnostic messages can be displayed
• Maintenance reminders
• System settings
◦
System voltage and percent load
◦
Voltage adjustment
◦
Measurement system, English or metric
• Programmable Interface Module (PIM) status
displays
◦
Input status (active/inactive)
◦
Output status (active/inactive)
14
Section 1 Descriptions and Service Views
1.6 Accessories
The following optional accessories are offered for the
6VSG generator sets.
1.6.1
An optional carburetor heater is recommended for
improved cold starting in locations where the ambient
temperature drops below 0°C (32°F). The carburetor
heater prevents condensation and carburetor icing.
The heater requires a continuous source of AC power.
See the generator set Installation manual for more
information.
1.6.2
The Kohler
allows monitoring and control of your 6VSG generator
™
set from a personal computer located in your home or
at other remote locations.
configured to send email or text message notifications
®
®
OnCue
in the event of a generator set fault.
Note: Be sure to obtain the correct version of the
OnCue
generator sets.
1.6.3
The optional Programmable Interface Module (PIM)
provides
programmable dry contact outputs for connection to
customer-supplied equipment.
controlled by the VSC controller, and can also be
controlled remotely using the OnCue
The PIM is mounted in a NEMA 3R aluminum
enclosure, which can be mounted indoors or outdoors.
See the installation instructions provided with the PIM.
1.6.4
The optional communications kit includes the following
factory-installed items:
• Interface board with factory-set inputs and outputs
and customer connection terminal blocks
• Fuel pressure switch
• Enclosure intrusion alarm switch
Carburetor Heater
®
OnCue
Generator Management
System
®
®
OnCue
Generator Management System
®
OnCue
kit for the VSC controller.
®
version 3.1 or higher is required for 6VSG
Programmable Interface Module
(PIM)
two
programmable
Communications Kit
®
OnCue
can also be
inputs
and
six
The outputs are
®
program.
TP-6843 7/15