J-Ex8200 Switch Default Configuration - Dell PowerConnect J-EX4200-24T Software Manual

Related
Documentation

J-EX8200 Switch Default Configuration

}
}
ge-0/1/3 {
unit 0 {
family ethernet-switching;
}
}
}
protocols {
igmp-snooping{
vlan all;
}
lldp {
interface all;
}
lldp-med {
interface all;
}
rstp;
}
ethernet-switching-options {
storm-control {
interface all;
}
}
poe {
interface all;
}
Reverting to the Default Factory Configuration for the J-EX Series Switch on page 341
Connecting and Configuring a J-EX Series Switch (CLI Procedure) on page 161
Connecting and Configuring a J-EX Series Switch (J-Web Procedure) on page 163
Understanding Configuration Files for J-EX Series Switches on page 321
J-EX Series Switches Interfaces Overview on page 863
Each J-EX8200 switch is programmed with a factory default configuration that contains
the values set for each configuration parameter when a switch is shipped. The default
configuration file sets values for system parameters such as the ARP aging timer, the
system log, and file messages, while also enabling the LLDP protocol, the RSTP protocol,
IGMP snooping, and storm control.
When you commit changes to the configuration, a new configuration file is created that
becomes the active configuration. You can always revert to the factory default
configuration. See "Reverting to the Default Factory Configuration for the J-EX Series
Switch" on page 341.
This topic shows the factory default configuration file of a J-EX8200 switch:
system {
arp {
Chapter 23: Configuration Management Overview
329