Transportation And Storage - Ryobi RBL42BP User Manual

FUEL FILTER
The fuel supplied to the engine is passed through a  lter
to remove any contaminants from entering the engine.
Contaminants in the fuel can cause poor performance and
damage to the engine.
The fuel  lter is a non-serviceable item and, if needed,
should be replaced by an authorised service centre.
SPARK PLUG REPLACEMENT
The product’s engine uses a Champion RCJ4 spark plug.
Use an exact replacement.
1. Remove the spark plug boot.
2. Loosen the spark plug by turning it counter-clockwise
with a socket.
3. Remove the spark plug.
4. Inspect the new spark plug. The spark plug must be
properly gapped and free of deposits in order to ensure
proper engine operation. The correct gap is 0.63 mm
(0.025 in.). To widen gap, if necessary, carefully bend
the ground (top) electrode. To lessen gap, gently tap
ground electrode on a hard surface.
5. Hand thread the new spark plug into the cylinder,
turning it clockwise.
6. Tighten with a socket. Torque to 216 in.lb. (24.40 Nm)
minimum, 264 in.lb. (29.82 Nm) maximum. Do not
over-tighten.
WARNING
Be careful not to cross-thread the spark plug. Cross-
threading will seriously damage the product.

TRANSPORTATION AND STORAGE

Stop the engine and allow it to cool before storing or
transporting.
Clean all foreign material from the product.
Drain all fuel from the tank into a container approved
for petrol. Remember to properly replace and tighten
the fuel cap.
Run the engine until it stops. This will remove all fuel
that could become stale and leave varnish and gum in
the fuel system.
Store the product in a cool, dry, and well-ventilated
place that is inaccessible to children and well away
from sources of ignition.
Keep away from corrosive agents such as garden
chemicals and de-icing salts.
Do not store outdoors.
English (Original instructions)
Short term storage (less than 1 month)
DESCRIPTION
See fi gure 6.
1. Upper tube
2. Throttle trigger
3. Cruise control
4. Ignition switch
5. Adjustable harness and waist straps
6. Choke lever
7. Lower tube
8. Bellows tube
9. Nozzle
10. Primer bulb
ASSEMBLY
UNPACKING
The product requires assembly.
Do not use the product if any parts on the packing list
are already assembled when you  rst open the box.
The parts on the packing list are not assembled by the
manufacturer and require customer installation. Use of
a product that may have been improperly assembled
could result in serious personal injury.
18
When transporting the product in a vehicle, secure
it against movement or falling to prevent injury to
persons or damage to the product.
Never carry or transport the product while the engine
is running.
Abide all government and local regulations for the
safety storage and handling of petrol.
Stop the engine, and allow it to cool before storing.
Store the product in a cool, dry, and well-ventilated
place that is inaccessible to children and well away
from sources of ignition.
Keep away from corrosive agents such as garden
chemicals and de-icing salts.
Do not store outdoors.
NOTE: the straps are "quick release" type.
Carefully remove the product and any accessories
from the box. Make sure that all items listed on the
packing list are included.
WARNING
Carefully inspect the product to make sure no
breakage or damage occurred during shipping.