Blower Safety Warnings; Transportation And Storage; Transporting Lithium Batteries; Maintenance - Ryobi RBL3600 Original Instructions Manual

36v cordless blower
Hide thumbs Also See for RBL3600:
Table of Contents

Advertisement

if the product starts to vibrate abnormally
(inspect immediately)
Immediately turn off the product and
remove the battery pack in the event of
accident or breakdown. Do not operate
the product again until it has been fully
checked by an authorised service centre.

BLOWER SAFETY WARNINGS

Wear a face filter mask in dusty conditions
to reduce the risk of injury associated with
the inhalation of dust.
Slightly
dampen
conditions.
Do not point the blower nozzle in the
direction of people or pets.
Never place objects inside the blower
tubes.
Do not operate the product near open
windows.
Use the full blower nozzle extension so that
the air stream can work close to the ground
and perform effectively.
Do not place the product on top of or near
loose debris. Debris can be sucked into the
intake vent, resulting in possible damage
to the product.
ADDITIONAL BATTERY SAFETY
WARNINGS
WARNING
To reduce the risk of fire, personal injury,
and product damage due to a short circuit,
never immerse the product, battery pack or
charger in fluid or allow fluid to flow inside
them. Corrosive or conductive fluids, such
as seawater, certain industrial chemicals,
and bleach or bleach-containing products,
etc., can cause a short circuit.

TRANSPORTATION AND STORAGE

Stop the product, remove the battery pack,
and allow it to cool down before storing or
transporting.
Clean all foreign materials from the product.
Store the product in a cool, dry, and well-
ventilated
place
to children. Keep the product away
from corrosive agents, such as garden
chemicals and de-icing salts. Do not store
the product outdoors.
surfaces
in
dusty
that
is
inaccessible
For transportation in vehicles, secure the
product against movement or falling to
prevent injury to persons or damage to the
product.

TRANSPORTING LITHIUM BATTERIES

Transport the battery in accordance with local
and national provisions and regulations.
Follow all special requirements on packaging
and labelling when transporting batteries by a
third party. Ensure that no batteries can come
in contact with other batteries or conductive
materials while in transport by protecting
exposed connectors with insulating, non-
conductive caps or tape. Do not transport
batteries that are cracked or leaking. Check
with the forwarding company for further
advice.

MAINTENANCE

WARNING
Use
only
original
replacement
parts,
attachments. Failure to do so can cause
possible injury, can contribute to poor
performance, and may void the warranty.
WARNING
Servicing
requires
knowledge and should be performed only
by a qualified service technician. Have the
product serviced by an authorised service
centre. When servicing, use only original
replacement parts.
Do not make adjustments and repairs not
described in this manual. For other repairs,
contact an authorised service agent.
After each use, clean the product with a
soft, dry cloth.
Check all nuts, bolts, and screws at
frequent intervals for proper tightness to
ensure that the product is in safe working
condition. Any part that is damaged should
be properly repaired or replaced by an
authorised service centre.
Bring the product to an authorised service
centre to replace damaged or unreadable
labels.
manufacturer's
accessories,
and
extreme
care
and
3

Advertisement

Table of Contents
loading

Table of Contents