Bosch IXO Original Instructions Manual page 32

OBJ_BUCH-3324-001.book Page 32 Tuesday, September 26, 2017 9:42 AM
32 | English
In order to charge plug the charging cable 13 into the socket 12 on the bot-
tom of the handle and into the battery charger 14. Subsequently plug the
mains plug of the battery charger 14 into a socket outlet.
The charging process is interrupted when the On/Off switch 7 is fully
pressed.
The battery charge-control indicator 4 indicates the charging progress. The
indicator lights up green during the charging process. When the battery
charge-control indicator 4 is no longer lit, the battery is fully charged.
During the charging procedure, the handle of the machine warms up. This is
normal.
Disconnect the battery charger from the mains supply when not using it for
longer periods.
The power tool cannot be used during the charge procedure; it is not defec-
tive when inoperative during the charging procedure.
 Protect the battery charger against moisture!
Observe the notes for disposal.
Changing the Tool (see figure B)
 Do not use double-sided screwdriver bits that are longer than 25 mm.
Insert the screwdriver bit 1 directly into the tool holder 2.
Adjusting the Worklight (see figure C)
By turning the rubber cap 3, you can set focused or diffused light for the work
area 10, if required. Pull the rubber cap forward and off and  place this
with the appropriate lens back on the tool holder 2.
Eccentric Driver Head/Angle Driver Head/
Torque Attachment (see figures C – F)
The eccentric driver head 15 enables screwdriving close to edges.
The angle driver head 16 enables screwdriving at hard to reach locations.
With the torque presetting ring 18 on the torque attachment 17, the request-
ed torque can be preset in 10 steps. With the correct setting, the tool bit is
stopped as soon as the screw is driven flush into the material or when the set
torque is reached.
1 609 92A 43H | (26.9.17) Bosch Power Tools