Making Wi-Fi Settings By Push Button Setup (Wps) - Epson XP-8500 Series User Manual

User's Guide
8. Tap OK to finish.
Note:
If you fail to connect, load A4 size plain paper, and then tap Print Check Report to print a connection report.
9. Tap Close on the network connection settings screen.
Related Information
"Entering Characters" on page 23
&
"Checking the Network Connection Status" on page 33
&
"When You Cannot Make Network Settings" on page 195
&

Making Wi-Fi Settings by Push Button Setup (WPS)

You can automatically set up a Wi-Fi network by pressing a button on the access point. If the following conditions
are met, you can set up by using this method.
❏ The access point is compatible with WPS (Wi-Fi Protected Setup).
❏ The current Wi-Fi connection was established by pressing a button on the access point.
Note:
If you cannot find the button or you are setting up using the software, see the documentation provided with the access point.
1. Tap on the home screen.
2. Tap Wi-Fi (Recommended).
3. Tap Start Setup.
If the network connection is already set up, the connection details are displayed. Tap Change Settings to
change the settings.
4. Tap Push Button Setup (WPS).
5. Hold down the [WPS] button on the access point until the security light flashes.
If you do not know where the [WPS] button is, or there are no buttons on the access point, see the
documentation provided with your access point for details.
Network Settings
30