Table of Contents
Advertisement
Frequency & Step Selection
To tune to a new frequency or change tuning steps, thè transceiver
must be in thè Dial mode. If a Memory number is present in thè upper
l e f t corner of thè display, press [D/MR] to select thè Dial mode*.
There are two ways to select your operating
frequency:
by turning
thè selector knob, or with thè [UP] and [DOWN] keys. Holding thè
[UP] or [ D O W N ] key* for more than i-second will start scanning
(press one of these keys again to stop).
Channel steps are 12.5 or 25 kHz in ali versions. To change from one
step size to thè other press [F]+[STEP]*. A small .5 kHz digit is dis-
played at thè right end of thè frequency on alternate 12.5 kHz steps.
One-megahertz steps are also available: just press [F] before turning
thè selector knob or pressing thè [UP]/[DOWN] keys.
Memory Storage & Recali
The FT-2311R offers ten programmable memory channels, numbered O
through 9. When in thè Memory mode, thè Memory number appears in
thè upper left corner of thè display. To store a frequency in memory:
(1)
Tune to thè desired frequency in thè Dial mode.
(2)
Press [F] + [M] (thè Memory number will blink) and select thè
desired Memory number for Storage using thè selector knob
or [UP]/[DOVVN] keys,
(3) Press [D/MR] to store thè Dial frequency into thè selected
Memory: thè Memory number will disappear,
and operation
will continue in thè Dial mode.
If
nothing happens when you press a key, see if there is a
small 'L' at thè lower left corner of thè display.
If so, press
[F] + [LOCK] to unlock thè keys.
-18-
Once thè Memory number starts blinking in step (2), you have a
maximum of four seconds between knob selections or keystrokes until
you press [D/MR] in step (3). If you time out, a memory number will
be displayed after you press [D/MR].
Simply start again at step (2).
Remember that when you store a memory, any data previously stored
in that memory is erased.
EXAMPLE:
to store 1295.000 MHz in channel O
(1)
Press [D/MR] once if a Memory number is displayed, to select
thè Dial mode. Then use thè selector knob or [UP] and [DOWN]
keys to select 295.000 on thè display*.
(2)
Press [F] + [M] and then rotate thè selector knob until 'O' is
displayed (blinking) at thè upper left corner.
(3) Press [D/MR]. There should now be no rnemory number dis-
played. If there is, you timed out (press [D/MR] and then repeat
step 2).
To recali prestored memories for operation,
thè transceiver must be
in thè Memory mode (Memory number displayed). Press [D/MR], if
necessary, to select thè Memory mode. The last memory channel used
is now be recalled.
Rotate thè selector knob or press thè up/down keys to select other
memories. Only prestored memories are displayed: empty memories are
skipped.
Note:
Memory O is a special 'Cali Channel Memory
1
, which can be
instantly recalled from any mode just by pressing [CALL]. Press [D/MR]
when finished to return to thè previously selected mode.
To exit thè Memories and return to Dial mode, press [D/MR].
*
Remember, thè 1-GHz digit is not displayed.
-19-
Advertisement
Table of Contents
