Frequency & Step Selection - Yaesu FT-23R MKII Operating Manual

Operation
F & S S
REQUENCY TEP ELECTION
To select a new operating frequency, the transceiver must be in the Dial mode (see box,
above). If you see a Memory number, press the [ D/MR ] key to switch to Dial mode. There
are two ways to select your operating frequency: by the DIAL selector on the top, or with
the [ p ] and [ q ] keys. For continuous tuning, press and hold the [ p ] or [ q ] key for more
than ½-second. One-Megahertz giant steps are also available: just press [ F ] + [ p ] or [ F ] +
[ q ] (and hold the second key for repeated stepping), or press [ F ] and rotate the DIAL
selector.
Channel steps are 5 or 10 kHz in versions A, D and E, and 12.5 or 25 kHz in versions B and
C. To change from one step size to the other for your version, press [ F ] + [ STEP ] *. In the
12.5/25 kHz versions a small .5-kHz digit is displayed at the right end of the frequency.
: If nothing happens when you press a key, see if there is a small "L" at the lower left
*
corner of the display. If so, press [ F ] + [ LOCK ] to unlock the keys.
FT-23R O M 13
PERATING ANUAL
MKII