Cord Wrap Facility (Specific Types Only) - Philips Sonicare HealthyWhite HX6762/35 User Manual

Hide thumbs Also See for Sonicare HealthyWhite HX6762/35:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
The Smartimer automatically resets to the beginning of a 2-minute
cycle if:
-
you stop brushing for 30 seconds or longer.
-
you put the handle in the charger.
Quadpacer (select models)
-
The Quadpacer is an interval timer that has a short beep and
pause to remind you to brush the 4 sections of your mouth evenly
and thoroughly. (Fig. 7)
-
When you use the two-minute Clean or Sensitive mode, you hear
a short beep and a pause in brushing action at 30, 60 and
90 seconds.
-
When you use the Clean and White mode, you hear and feel a
change in the brush head sound and motion after 2 minutes of
Clean mode. Then move the brush head to the visible upper front
teeth and brush them for 15 seconds. At the final beep and pause,
move to the visible lower front teeth and brush them for
15 seconds. (Fig. 9)

Cord wrap facility (specific types only)

If your Sonicare type includes the deluxe charger cover and base, the
travel charger is pre-installed inside the cover. If you want to shorten
the mains cord, you can store excess cord in the cord wrap facility in
the charger base.
1
To separate the charger cover from the charger base, press the
two grey snap bars on the charger base and pull the white charger
cover upwards. (Fig. 10)
2 Wrap excess mains cord around the grey charger base as shown in
the picture. Make sure you wrap the cord on the inside of the two
snap levers. (Fig. 11)
3 When you have stored the excess cord, guide the mains cord through
the small groove in the rear of the grey charger base. (Fig. 12)
4 To reattach the charger cover, press it down over the charger base
until it snaps into place.
Tip: For extra convenience during travel, you can remove the travel
charger and use it without the charger cover and charger base.
13
English

Advertisement

Table of Contents
loading

Table of Contents