Cord Wrap Facility (Specific Types Only); Toothbrush Handle - Philips Sonicare HealthyWhite 700 Series User Manual

- When you use the Clean and White mode, you hear and feel a
change in the brush head sound and motion after 2 minutes of
Clean mode. Then move the brush head to the visible upper
front teeth and brush them for 15 seconds. At the final beep and
pause, move to the visible lower front teeth and brush them for
15 seconds. (Fig. 9)

Cord wrap facility (specific types only)

If your Sonicare type includes the deluxe charger cover and base, the
travel charger is pre-installed inside the cover. If you want to shorten
the mains cord, you can store excess cord in the cord wrap facility in
the charger base.
1 To separate the charger cover from the charger base, press the
two grey snap bars on the charger base and pull the white charger
cover upwards. (Fig. 10)
2 Wrap excess mains cord around the grey charger base as shown in
the picture. Make sure you wrap the cord on the inside of the two
snap levers. (Fig. 11)
3 When you have stored the excess cord, guide the mains cord
through the small groove in the rear of the grey charger base. (Fig.
12)
4 To reattach the charger cover, press it down over the charger base
until it snaps into place.
Tip: For extra convenience during travel, you can remove the travel
charger and use it without the charger cover and charger base.
Cleaning
Do not clean brush heads, the handle, the charger or the charger
covers in the dishwasher.

Toothbrush handle

1 Remove the brush head and rinse the metal shaft area with warm
water. Make sure you remove any residual toothpaste (Fig. 13).
Caution: Do not push on the rubber seal on the metal shaft with
sharp objects, as this may cause damage.
2 Wipe the entire surface of the handle with a damp cloth.
13
English