Turning The Appliance Off; Menu Settings; Rinsing; Descaling - DèLonghi ECAM 650.85 Instruction Manual

7. TURNING THE APPLIANCE OFF

Whenever the coffee machine is turned off after being used to
make coffee, it performs an automatic rinse cycle.
Danger of burns!
During rinsing, a little hot water flows from the coffee spouts
(A8). Avoid contact with splashes of water.
• To turn the appliance off, press the
9).
• The message "Turning off Please wait" is displayed, then
the appliance performs a rinse cycle and goes off (standby).
Please note!
If you will not be using the appliance for some time, unplug from
the mains socket:
• first turn the appliance off by pressing the
(fig. 9);
• release the main switch (A21) at the back of the appliance
(fig. 2).
Important!
Never press the main switch while the appliance is on.

8. MENU SETTINGS

8.1

Rinsing

Use this function to deliver hot water from the coffee spouts (A8)
and hot water/steam spout (C6), if inserted, to clean and heat
the appliance's internal circuit.
Place a container with a minimum capacity of 100ml under the
coffee and hot water spouts (fig. 8).
To enable the function, proceed as follows:
1. Press " " (B2) to enter the menu;
2. Press < (B10) or > (B8) until "
display (B);
3. Press " " to start rinsing.
Important! Danger of burns.
Do not leave the appliance unattended while hot water is being
delivered.
4. After a few seconds, hot water is delivered first from the
coffee spouts, then from the hot water/steam spout (if
inserted) to clean and heat the appliance's internal circuit.
"RINSING UNDERWAY, HOT WATER FROM SPOUTS" appears
on the display, together with a progress bar which fills
gradually as preparation proceeds;
5. To stop rinsing, press "
stop automatically.
Please note!
• If the appliance is not used for more than 3-4 days, when
you turn it on again, we strongly recommend performing
2/3 rinses before use;
button (A7-fig.
button
RINSING" appears on the
" or wait for rinsing to
11
• After cleaning, it is normal for the grounds container (A10)
to contain water.

8.2 Descaling

For instructions on descaling, see section "19. Descale".

8.3 Water filter

For instructions on how to install the filter (C4), see section "21.
Water softener filter".

8.4 Beverages settings

In this section, you can consult your customised settings and, if
you wish, reset the default values for each beverage, except cold
coffee, cold milk and chocolate.
1. Press " " (B2) to enter the menu;
2. Press < (B10) or > (B8) until "
pears on the display (B);
3. Press " ". The values for the first beverage appear on the
display;
4. The reference user profile is highlighted on the display. The
values are displayed on vertical bars. The default value is
indicated by the
highlighted by the solid part of the vertical bar;
5. To go back to the settings menu, press "
To scroll and display the beverages, press "
6. To reset the default values for the beverage displayed, press
" RESET";
7. "CONFIRM RESET?": to confirm, press "
press " ");
8. "DEFAULT VALUES SET": press "
The beverage has been reset to the default values. Continue with
the other beverages, or go back to the settings menu.

8.5 Set time

To adjust the time on the display (B), proceed as follows:
1. Press " " (B2) to enter the menu;
2. Press < (B10) or > (B8) until "
the display (B);
3. Press " ". The time setting panel appears on the display;
4. Press < or > corresponding to the hours and minutes until
the current time is displayed;
5. To confirm, press "
then press " " to go back to the homepage.
The time is now set.

8.6 Auto-start

You can set the auto-start time in order to have the appliance
ready at a certain time (for example in the morning) so you can
make coffee immediately.
DRINKS SETTINGS" ap-
symbol, while the current value is
".
" (to cancel,
".
SET TIME" appears on
" (to cancel, press "
";
"),