DèLonghi ECAM 650.85 Instruction Manual page 27

The appliance does not come on
The infuser cannot be extracted
At the end of descaling, the appliance
requests a third rinse
The milk does not come out of the
milk spout (D5)
The milk contains large bubbles and
squirts out of the milk spout (D5) or
there is little froth
The cup warmer is hot, even though it
has been disabled
The chocolate is not sufficiently dense The hot chocolate powder does not
The hot chocolate is cold or there are
lumps
During cleaning, there are traces of
black on the stirrer (E4)
The power cord (C8) connector is not
inserted correctly.
It is not plugged into the mains socket. Plug into the mains socket (fig. 1).
The main switch (A21) is not turned on. Press the main switch (fig. 2).
The appliance has not been turned off
correctly
During the two rinse cycles, the water
tank (A16) has not been filled to the
MAX level
The lid (D2) of the milk container (D)
is dirty
The milk is not cold enough or is not
semi-skimmed.
The froth adjustment dial (D1) is incor-
rectly adjusted.
The milk container lid (D2) or froth ad-
justment dial (D1) is dirty
The hot water/steam connection noz-
zle (A9) is dirty
A number of beverages have been pre-
pared in rapid succession
contain thickener.
The highest density has not been
selected.
Incorrect quantities of milk and hot
chocolate powder.
The stirrer (E4) and steam spout (E3)
are not inserted correctly in the funnel
(E2).
The instructions have not been
followed.
The magnets in the stirrer attract trac-
es of iron naturally present in the hot
chocolate powder.
32
Insert the connector as far as it will go in the
socket at the back of the appliance (fig. 1).
Turn the appliance off by pressing the
ton (A7) (section "7. Turning the appliance off").
Follow the instructions displayed by the appli-
ance, but first empty the drip tray (A14) to avoid
the water overflowing.
Clean the milk container lid as described in sec-
tion "10.1 Cleaning the milk container".
Use skimmed or semi-skimmed milk at refrig-
erator temperature (about 5° C). If the result is
not as you wished, try changing brand of milk.
Adjust following the instructions in section
"10.2 Adjusting the amount of froth".
Clean the milk container lid and froth adjust-
ment dial as described in section "10.1 Clean-
ing the milk container".
Clean the connection nozzle as described in
section "8.1 Cleaning the hot water/steam
connection nozzle".
Change the type of hot chocolate powder.
Select maximum density in the corresponding
screen.
Respect the instructions in section "14. making
hot chocolate".
Insert the stirrer and steam spout on the
funnel.
Pour the milk/water into the funnel (E2) first,
followed by the hot chocolate powder.
Clean as described in section "8.2 Cleaning the
"Mix Carafe" (E)".
but-