LOGO BADGE RELOCATION
When reversing doors:
2. Immediately center the badge over screw hole in opposite side of door and press firmly
DOOR HANDLE INSTALLATION
For models with pre-installed handle-moun
1. Remove door handles and screws fr
to secure it. (Screw may need to be loosened slightly if handle is difficult to slide on).
3. Rotate door handle toward the space between the doors.
4. Install screws from par
5. Repeat above steps for remaining door.
6. With both handles mounted, visually align handles, car
For models without pre-installed handle-moun
1. Remove door handles, screws and handle trim pieces fr
2. Mount the tapered end of the handle to the door face using one of the two door face screws from the door
handle bag.
4. Repeat above steps for remaining door.
5. With both handles mounted, visually align handles, car
6. A
rim pieces to handles.
rews on the faces of the doors:
s.
hten fully.
rews on the faces of the doors:
PAGE 8 • SET UP & USE
hten screws.
s.
hten screws.